I don't use if enough to make a noticeable difference in the electric bill. $250 - $400.Īlso I do have access to 208 so "IF" I do have to swap it out I will likely wire it all for 208.ĭoes that add any Real Power to the party or is it just mostly just cooler/smoother running? I have found that motors that fit the spec's are NOT Cheap.
#Old craftsman table saw upgrade
I am curious as to "IF", I find it is not easily fixed and need to replace it if the larger motor Mfg's overate their motors to the same extent?Īnd all things equal would anyone here think it would be reasonable to upgrade to a 1.5 HP Motor TEFC, to keep out the saw dust, and add a little power. (and YES I have nice Sharp Carbide Tip Blades Several in different tooth combinations) Try to rip a 2x4 and you have to feed it like a baby. I've always thought the saw could use a little more power as it slows down cutting anything thicker than a 1" thick anything. I've heard that Craftsman overstated the HP of there motors by a substantial margin. NOTE: I do stick a Stubby Vacuum Tool up to the vents frequently which is probably what has saved me so far.īut none of that is why I'm posting here.
#Old craftsman table saw full
I also fully expect to find it packed full of sawdust as I can see some in the vent. I've done the basic internet research and will over the weekend look into both the Start Cap and Centrifugal Switch. But considering you can get something like this (2.7 hp, also Craftsman, nicer fence, newer so probably smoother action on the turn wheels, great condition) for $100, I would say wait for a better deal unless you need a saw urgently or could get the saw you listed for a reduced price.This week I was cutting some parts on my table saw for a current project when it suddenly decided to just BUZZ and not run. You can find better deals that don't require as much work to clean up (not that you have to, this saw appears to be absolutely function). I've never been a fan of the tables of that era of Craftsman because I prefer just flat cast iron.but that's just a personal preference. It is almost definitely a universal motor with brushes as opposed to an induction motor that you typically find on belt drives - which means it's going to be fairly loud as table saws go. It's a direct drive motor that I believe is 1.5 hp, which get's the job done, but is nothing spectacular. The fence on these aren't the best in my opinion, I find they tend to not be too smooth, but it'll get the job done. It has a left tilt and table extensions which are nice. I see these go for $125-150 around me when they're in better condition. Yeah I would say that price could accurately be described as decent. No top-level wood ID, low effort, or price queries No memes, image macros, reaction gifs/videos, etc. Projects related to firearms, religion, or flags will be allowed but locked. Includes but not limited to religious and political topics. No reposts, rehosted, or freebooted content. go to for a detailed explanation of the rules.ĭon’t be rude. Before posting, check that your content doesn't violate the rules below. r/woodworking is a forum that encourages the respectful exchange of woodworking knowledge and projects. It IS under reconstruction right now, so we apologize for broken links, etc. "How do I start?") and links to many valuable resources. BEFORE ASKING A QUESTION, DID YOU READ OUR WIKI? Our Wiki includes answers to common questions (e.g.